Operation skills:
1, Air gap when cutting, avoid cutting air gap is greater than 0.5mm. In the air gap in the nozzle divergent trend, it will cause the lower layer cutting surface roughness. Stack cutting, keep the sheet neatly stacked together.
2, Automatic loading and unloading, most machines do not use automatic loading and unloading techniques, such as the space shuttle.
3, Increase or decrease of water pressure by the controller.
4, Ordinary tap water, waterjet system uses ordinary tap water. 90% of pure waterjet and abrasive waterjet users require only water softening process to go through before the water filters through the pump into the turbocharger inlet. Reverse osmosis and deionization technology can greatly extend the life of the nozzle, but also cause costly damage to the turbocharger and high-pressure pipe.
5, Control system specially designed for the process, is usually more efficient and easier to use than the general multi process control.
Waterjet cutting mechanical features:
1, Can be configured dual cutting heads to increase productivity.
2, The actual cutting surface without burr, generally do not need the postprocessing.
3, Clean and safe process.
4, Low temperature processing, no dust and no harmful gases, are environmentally friendly.
5, Cutting fluctuation is absorbed by water, low noise.
6, By integrating the debris conveyor, continuous transport of waste abrasive and cutting excess material.
Information source from http://www.waterjetnozzles.com
No comments:
Post a Comment