Waterjet parts / waterjet cutting machine routine maintenance

Waterjet parts and water jet cutting machine routine maintenance is very important. It is directly related to the waterjet parts and water jet cutting machine life and cutting performance.

1, Waterjet parts and waterjet cutting machine should be placed in ventilated and dry place, avoid moisture.

2, Waterjet parts storage room and water jet cutting machine room should not have corrosive gases.

3, Waterjet gearbox lubrication should generally be six months once, and should be regularly add lubricating oil to the transmission shaft.

4, Rainy day do not use water jet cutting machines and waterjet parts outdoors, to prevent the electrical system be affected with damp and cause an electric shock accident.

5, Waterjet Parts and waterjet cutting machine should be done the outside clean-up inspection before use, the body, the cutting torch and must adjust the gap between the moving parts, not loose; meanwhile to check whether the loosening fasteners, if loose should timely tighten.

6, Cutting worker break or leaving the workplace for a long time, the power must be cut off to prevent the motor overheating and burned out.

7, Waterjet cutting machine must have a person responsible for maintenance and regular maintenance. After work should do the cleaning work.

8, When found in the waterjet cutting machine commutation failure, can use the method of replace the fuse, repair the pressure switch, replace the clutch pressure wheel or replace the motor and control circuit elements to eliminate.

9, When found in the waterjet cutting machine trolley car walking instability with skid phenomenon, should guide processing straight, repair or replace the active roller, increase the weight of the car.

10, When the circuit voltage is too low, can use the voltage regulator to increase the voltage.

11, When the water jet cutting machine knead arm profiling gas cutting machine magnet wheel does not turn, should replace the fuse, repair pressure switch or replace the motor and control circuit elements.

12, When the water jet cutting machine rocker arm type profiling cutting machine magnet wheel slip fault, shall repair or replace the magnet roller, an appropriate increase in the thickness of the sample or removal of foreign matter in the rocker arm shaft and adding lubricating oil.

In short, only do a good job of waterjet parts routine maintenance, in the using process of the machine to give full play of the use performance, meet the technical requirements of the cutting process.